Uwzcwe4jq2vyrg4oyh4 Info

: Always start with a clean "reference edge" by trimming the factory edge of your plywood before making parallel cuts.

: The set includes a Parallel Guide (main extension) and Extensions for wider cuts. Installation : Slide the bracket into the rear groove of the guide rail. UwzCWe4JQ2VYrg4oyh4

: Crucial for accuracy. Align the stops with a pencil mark on a fresh splinter guard cut. Use a flathead screwdriver to fine-tune the bracket position if the measurement doesn't match the scale. 3. Operational Best Practices : Always start with a clean "reference edge"

: When using an MFT/3 Multi-Function Table, ensure the guide rail is long enough to clear the board at both the start and end of the cut to prevent kickback. 4. Alternatives & Enhancements Festool Parallel Guides : Crucial for accuracy

This system allows for repeatable parallel cuts without manually measuring and marking each piece.

: Recommended for ripping 8-foot sheets or edge-jointing lumber up to 9 feet. It provides a single, perfectly straight reference edge that is more reliable than connecting two shorter rails.