: Ensure all equipment is turned off and the PP 2 is disconnected from its power supply. Connect Turntable :
If you encounter issues, refer to the following common solutions: :
Check if the . If not, verify the power supply connections. Ensure the correct input is selected on your amplifier. Hum or Buzz : Nad Phono Preamp Pp2 Manual
: Verify that the PP 2 is connected to a standard Line-Level input and not a Phono input on your receiver. Phono Preamplifier PP 2 - HiFi Gear
: Never connect the PP 2 to an input marked "PHONO" on your receiver, as this will cause severe distortion. : Ensure all equipment is turned off and
: Connect the external 24V power supply to the PP 2 and plug it into a wall outlet. A green LED on the front panel indicates the unit is powered. 2. Technical Specifications
Ensure the turntable's ground wire is securely attached to the PP 2 . Ensure the correct input is selected on your amplifier
: If your turntable has a separate ground wire, secure it to the GND thumb screw on the back of the PP 2 to minimize hum.